Super Soundproofing Community Forum

Soundproofing Forum Topics => Building a Sound Control room and a place for My Band to practice in! => Topic started by: PSchlek on June 24, 2017, 02:57:51 AM

Title: Sound isolation in attached garage
Post by: PSchlek on June 24, 2017, 02:57:51 AM
Hi All,

I'm about to convert an attached, basement-level garage into a practice/teaching studio for percussion. Since this room is in the basement, and these are loud instruments, isolation is a priority. I've never done anything like this, but I have been doing a lot of research.

I intend to build MSM walls. Should I leave the existing walls alone and build new stud walls inside the room, leaving space in between both sets of walls, or should I break the plaster off of the existing walls in order to create more air space, and then build new walls inside the room, without external plasterboard on them? While the latter method seems counterintuitive, the book I'm reading ("The Studio Builder's Handbook" Owsinski/Moody) seems to suggest that this method would be better for sound isolation.

The house was built in 1926, and I'm not sure about the exact construction of the existing walls, but I can tell that I am dealing with stud walls that have some sort of coating on them, maybe painted plaster.

Thank you!
Patrick
Title: Re: Sound isolation in attached garage
Post by: Randy S on September 21, 2017, 03:42:30 PM
there is some value lost with a triple leaf system. this is why they tell you to remove the existing layer..
The key here is when you build the new frame and insulate both you need to load the new frame with as much mass as you can.

Randy S.