Recent Posts

Pages: « 1 2 3 4 5 6 7 8 9 10 »
51
#2 lb mass loaded vinyl or a couple layers of 1/2" permabond

Randy S.
52
What do you suggest for mass?
the interior wall is behind kitchen cabinets so have to add outside.
53
ok so not exposed directly to outside but in a wall...ok great ...

you can use standard Roxul batt insulation and double frame construction followed by lots and lots of mass.

The heavier the better for low frequency attenuation.

 Randy S.
54
Outside.  Opening up existing 2x4 walls to hopefully staggered studs or double studs.

55

what is your project for outside? kind of hard to make recommendations without all of the information.

Randy S.
56
Thanks.

Is roxul comfortboard a good option for outside?

Is there a big difference between the 80 vs 110?
57
Other Soundproofing Questions / Re: Basement ceiling soundproofing
« Last post by Randy S on August 29, 2017, 03:32:59 PM »
Bill,

You can use fiberglass since you are doing minor soundproofing..Mass is what you need and as much as you can put in..

you need to at least double the weight to see a 5db drop (40% of human speech) the more the mass the better the reduction.

The channel allows for complex structure and improves basic direct applied systems.

Randy S.
   
58
use roxul or therma fiber or even cotton fiber would be best bang for buck.

Randy S.
59
Other Soundproofing Questions / Re: Basement ceiling soundproofing
« Last post by martin1b on August 28, 2017, 06:48:14 PM »
Thanks for the reply Randy. I'm on a budget and am trying to stop sound transmission between levels, such as talking. I can clearly hear conversations in the floor above me. Impact noise would be a bonus but not required.

To do this, would be GG/DD be the best way? RC and 1 sheet is doable and probably less expensive than GG/DD but does that only stop impact noise?  Also, how much insulation should I add AND can I use fiberglass insulation?

Bill
60
Other Soundproofing Questions / Re: Basement ceiling soundproofing
« Last post by Randy S on August 28, 2017, 05:21:21 PM »
you most definitely need to insulate, do not leave the cavity hollow.

if you do not use channel then you want to go with 2 layers of 5/8" type X drywall with green glue.
you have to get the mass up in order to reduce air borne noise.

with out channel you do not get impact or low frequency reduction.

Randy S.
760-752-3030
Pages: « 1 2 3 4 5 6 7 8 9 10 »